Basic Information
1 HDMI Input, 1 HDMI Output, 1 SDI Input, 4 SDI Outputs.
Set Output mapping under "Control". Either set an Output to the HDMI Input, the SDI Input, or the Scaler.
Make sure "DUC Source" is set to whichever Input connector you're using; either SDI In or HDMI In.
Tip: Use 1080s29.97 for Graphics on an interlaced system.
Use SDI Output 2 first (set Output1 is loop, off).
Setup>LOAD DEFAULTS is a good reset if having issues.
5 Comments
What resolution is “1080s29.97”? Does it differ from Interlaced or Progressive? Or did you simply not spellcheck your work?
In reply to #1
I believe it's referencing psf (progressive segmented-frame), which shows as just "s" on the decimator. It's a way to send a progressive-frame source to an interlaced output (such as older broadcast TV). It's basically a combination of the fields of interlaced with the timing of progressive scan.
Progressive segmented frame - Wikipedia
In reply to #2
The above statement is correct. Thank you for the answer, whoever that was!
Heard a rumor that we have a file for Decimator defaults. Could we link that here in the wiki?
Thanks!
In reply to #3
We do not have any sort of Configuration file saved to load onto Decimators.
To Factory Default, click the left arrow button over to “Setup”, then click the Enter button to apply “Load Defaults”. This will clear any weird configuration that may be active.
From there, navigate to the Control menu and adjust settings as needed.