Wiring with a CDT-520 horn and PRX412 on same amp

When using the CDT-520 horns, you notice that they don't have a lot in terms of lower frequencies.  We have started to use them with the prx412s to try and make them less abrasive.  This usually is set up with the horn being hung on a tower and the PRX on a stand under it.  The "CDT+PRX" scene will allow you to use a single amp for both.

Wiring

On the preset, the CDT-520 comes out of Output 1 and the PRX come out of Output 2.  For the input, I would run an XLR into Input 1 and jump to Input 2 with a short XLR.  That way, they will both get the same signal, but you will have separate attenuation controls for the output.