Quick Start

Connect an ethernet cable from your processor to your laptop running COEX VMP.

It should auto populate on the side. Select that processor. When you do you will likely see the last show configuration that was used on that processor.

Across the bottom you will see Panel counts as you connect panels to the ethernet ports of the processors and it will tell you what % of total capacity the port is at.

To patch your runs you click a port and then click and drag across the mapping screen above. If it does not map the same way that you did there are different varieties of flow you can select at the side of the window.

On the source tab you select what source you want feeding the wall and can set the resolution of your screen.