Panansonic PTZ Camera Setup and Weblink to Manual

https://pro-av.panasonic.net/en/products/aw-ue160/

Panasonic PTZ Camera Setup

AW-UE160 + AW-RP150  |  LAN Control Configuration

Prepared: April 20,28, 2026

1.  Signal Flow

The diagram below shows the physical LAN signal path from the camera controller to the robotic camera. Two PoE+ injectors supply power to the devices over the ethernet cable, with an unmanaged switch bridging the two cable runs.

AW-RP150 Camera Controller

LAN port → PoE OUT

PoE Injector (PoE+ 802.3at)

Data IN → Switch

Unmanaged Network Switch

Switch → Data IN

PoE Injector (PoE+ 802.3at)

PoE OUT → LAN port

AW-UE160 Robotic Camera

Both PoE injectors must be PoE++ (802.3bt) rated - standard PoE is insufficient to power the AW-UE160. 

Injectors need to be set to BT. Power cycle the device if the POE injector toggle has been changed. 

2.  IP Address Configuration

Both devices must reside on the same subnet with unique IP addresses. The confirmed working configuration is as follows:

Device	IP Address	Subnet Mask
AW-UE160 Camera	192.168.0.1021 thru 29	255.255.255.0
AW-RP150 Controller	192.168.0.910 thru 12	255.255.255.0

Note: TheEvery camera initiallyand reportedcontroller anhas IPbeen ofset 192.168.0.11with viathere own ip address. It is labeled on the Easydevice. IPPlease Setupdon't Tool. Changing it to 192.168.0.10 viachange the camera'sip webaddress. GUI

—

 and

then

 updating the RP150's manual IP target to match — resolved the control issue. The exact reason this change was necessary is not entirely clear, but aligning both devices to these addresses established communication successfully.

3.  Camera Webto GUI — InitialController Setup

Before4. the controllerEasy couldIP communicateSETUP withTOOL the- camera, the following steps were completed via the camera's built-in web interface. Note: on a brand new camera with no existing users, the GUI will prompt you to create the first user account before allowing any access..Panasonic

1)    Open If for any reason you need to go into the the Easy IP SetupSETUP ToolTOOL.exe (EasyIPSetUpTool.exe). The camera will appear infor the deviceunit list.the username and password are below:

2) Click the Web GUI button in the tool. This opens a browser window pointing to the camera's interface.

3)     If this is a new camera with no users: follow the prompt to create the first user account. If a user already exists, log in with the existing credentials. For this unit — Username: markeys | Password: 2909.2909

4)     Once logged in, switch from Live to Setup mode using the toggle at the top of the interface.

5)     In the left navigation menu, scroll down and select Network, then choose LAN.

6)     Under IPv4 Network Settings, update the IP address from 192.168.0.11 to 192.168.0.10 and save.

a)     Note: If the camera has been on for 20mins you will have to power cycle it before updating these settings.

7)     On the AW-RP150, set the Manual IP target address to 192.168.0.10 to match the camera. Control was then established.